Furuno FI-70 Frount Mount Installation Kit

Furuno FI-70 Frount Mount Installation Kit

The optional frontmount kit OP26-29 may be used to install the FI-70 where access behind the console is limited.

Note: Do not fit the flushmount sponge to the FI-70. The unit will not lock into the frontmount panel.

1. Using the template supplied with the frontmount kit, cut a hole in the mounting location.
   
2. Fit the snap pins (supplied) to the FI-70, as shown in the figure below.
3. Fit the frontmount panel to the console with four self-tapping screws (supplied).
4. Referring to page 4, connect and ground the FI-70.
5. Set the FI-70 into the frontmount panel, using the snap pins and snap pin slots as guides.
6. Push the FI-70 into the frontmount panel until a "click" sound is made, indicating that the FI-70 is now secure
   in the panel.