Starbrite Snappy Teak-Nu 2-Part Teak Cleaner and Restorer - Formula 1 - 4lEasy to use two-part teak cleaner and restorer - Must use with Step 2 as the chemical reaction between the two products is what makes teak look brand new.
- Remove grey weathering, dirt, rust, fish blood and fuel stains, leaving teak with that freshly sanded look
- No hard scrubbing or bronze wool required
- Will not soften deck seam
Directions
Snappy™ Teak-Nu™ Formula No. 1 must be used with Snappy™ Teak-Nu™ Formula No. 2 to achieve best results.
FOR BADLY SOILED, OILED OR COATED TEAK:
1. Wear protective gloves. Apply Snappy™ Teak-Nu™ Formula No. 1 directly to wet deck. Use a medium bristle brush to spread evenly across the area to be treated. When the treated area darkens to a uniform dark brown, use a coarse bristle brush to scrub lightly. Avoid contact with painted or varnished surfaces. Rinse brushes after use.
2. Next, use a bristle brush to spread Snappy™ Teak-Nu™ Formula No. 2 uniformly over the treated area, then use a coarse bristle brush to loosen and remove dirt. The treated area will lighten to a golden brown. Rinse treated area thoroughly with water. When the treated area is completely dry, the deck will look like it has been freshly sanded.
FOR LIGHTLY SOILED TEAK:
1. Wear protective gloves. Use water to dilute Snappy™ Teak-Nu™ Formula No. 1 to an approximately 50% solution. Use a medium or soft bristle brush to spread evenly over area to be treated. When the treated area darkens to a uniform dark brown, use a medium or soft bristle brush to scrub lightly. Avoid contact with painted or varnished surfaces. Rinse the brush thoroughly after use.
2. Next, use water to dilute Snappy™ Teak-Nu™ Formula No. 2 to an approximately 50% solution, then use medium to soft bristle brush to spread uniformly over the treated area. Use medium to a soft bristle brush, scrubbing lightly to attain a uniform light colour. Rinse treated area thoroughly.
When the treated area is completely dry, the deck will look like it has been freshly sanded.
HELPFUL SUGGESTIONS
Immediately rinse off any drips, spills or splatters of Snappy™ Teak-Nu™ Formula No. 1 on painted or varnished surfaces, aluminium, fibreglass or any surface other than teak. Snappy™ Teak-Nu™ Formula No. 1 may damage paint or varnish if not immediately removed. Rinse brushes after each use.
To help avoid drips, spills or splatter onto painted or varnished surfaces adjacent to teak being treated, apply Snappy™ Teak-Nu™ Formula No. 1 with a paintbrush. Spray a mist of water on any areas which have dried before applying Snappy™ Teak-Nu™ Formula No. 2.
Snappy™ Teak-Nu™ Formulas Nos. 1 and 2 can be used on bare mahogany before refinishing to remove discolourations without bleaching the wood.
| 
